Basic phoenix awardbios cmos setup utility windows xp

BASIC PHOENIX AWARDBIOS CMOS SETUP UTILITY WINDOWS XP HOW TO
BASIC PHOENIX AWARDBIOS CMOS SETUP UTILITY WINDOWS XP PASSWORD

But if you need to recover Windows login password, then you can get Password Recovery Bundle to recover your lost or forgotten Windows admin/user passwords. Since using the program is a bit complicated, make sure to read the instructions provided beforehand. On laptops the CMOS password is usually stored in a EEPROM on the motherboard, so you need a EEPROM programmer to retrieve it. However, DO NOT kill the CMOS if you are recovering the password for a laptop. Back to Windows XP, 2000, 2003, NT Next Unread Topic. The location and method for doing this varies according to the maker of he motherboard in question. If that doesn't work, you can kill the BIOS using the /k switch. If you want to get into bios to try to fix things the easiest way without knowing the password is to open your case and move the jumper to reset all cmos settings to default. To recover the password, you need to note the value to the right of the BIOS you have installed and then you have to type in cmospwd /m to execute the module. You'll get a list of possibilities which you can compare against your BIOS manufacturer. At the command prompt, type in CMOSPWD and press Enter key. Using the program requires a little bit of the command prompt, so make sure you are familiar with that before using it.Д«asically, to run it, go to the command prompt and use CD command to navigate to the directory where you stored the file. The BIOS contains all the settings and the CMOS memory is a piece of RAM that remembers all the info. The BIOS and CMOS often get confused but there is quite a difference. If you are lucky enough to have one of these, you may be able to recover the password easily. The computer BIOS setup utility (also known as the CMOS setup) is the place where you can change a few basic computer hardware settings. Now this program won't work with all BIOS out there, but here are the ones it will work with: The program basically decrypts the password that is stored in CMOS, which is used to access the BIOS setup. CMOSPwd works under Dos, Windows 98, Windows NT, Windows 2000, Windows XP, Windows 2003, Windows Vista, Windows 7, Windows 2008, Linux, FreeBSD, and NetBSD. I recently ran across another program that you can use to recover a CMOS or BIOS password. Earlier, I had written about a way to remove BIOS password using the jumper settings. If you can't remember a BIOS or CMOS password, you're pretty screwed because you won't be able to even boot up Windows. The password you configure for your BIOS is required by you whenever you turn your computer on in order to boot your installed operating system. To change which device to boot from first, follow the directions on the BIOS setup utility screen to change the boot order. Once the Boot menu has been found, search for the Boot Order to be changed. BIOS been present in the computer from the pre-initial stage of it's use even before you turn on your computer. The steps listed below are for the example BIOS only, the computer's BIOS may be slightly different.

BASIC PHOENIX AWARDBIOS CMOS SETUP UTILITY WINDOWS XP HOW TO

This concludes how to access the Boot Menu from a Phoenix Award BIOS and set your System to Boot with USB.BIOS is a kind of software situated as a chip in the motherboard of your computer. You can now proceed to boot Linux from your USB flash drive. If all went well, you should be presented with a boot screen containing your Live system. If you have properly formatted, activated the partition and installed Linux to your USB device, you can reboot.Note: If your USB device is not listed, you may need to set a boot flag on it to mark the partition active, so it can be detected as bootable. Use the up/down arrow keys to select your Bootable USB from the list, and then press enter.You should now see a menu similar to the one shown below. Use the up/down arrow keys to select the Hard Disk option from the menu and press Enter to accept.You should now be presented with a boot screen. Some commonly used BIOS Boot Menu keys are F2, F10, F11, and ESC Note: The key used to access your Boot Menu may vary. During the system post tap the F11 key (or the key your specific board manufacturer specifies) to get into Boot Menu.First insert a bootable USB flash drive into your computer, and reboot.How to Set Boot Menu to Boot from USBДЄccessing the Boot Menu or Boot Manager on a Phoenix or Award BIOS to set a computer to Boot with USB. At that time, this system was easily able to boot from any properly setup bootable USB or external hard drive I have thrown at it. The system used for this demonstration featured an MSI K8N Neo4 (MS-7125) motherboard.

Basic phoenix awardbios cmos setup utility windows xp